Flame and flow characteristics of an excited non-premixed swirling double-concentric flame

Closed

Ching Min Hsu, Michael Estela Loretero

2015 Experimental Thermal and Fluid Science Vol. 62 Article Cited by 5 Quartile

Abstract

The flame behaviors and velocity fields of unexcited and excited swirling double-concentric jet flames were experimentally studied. Acoustic excitation was applied to the central fuel jet. The central jet Reynolds and swirl numbers were 2386 and 0.426, respectively. Three characteristic flame behaviors, wrinkled base flame, converged base flame, and diverged base flame were observed by the traditional photographic technique. Jet pulsation intensity dominated the change in the characteristic flame modes. We used a high-speed particle image velocimeter to measure the time-averaged velocity field; results of the excited swirling double-concentric jet flames showed that the streamlines that separate from the central fuel jet exit were significantly deflected toward the central jet axis, while the size of the rotating-inward single-ring vortex decreased as the jet pulsation intensity decreased. Partial flow emitted from the annular air jet flowed over the outer contour of the rotating-inward single-ring vortex and was then entrained into the central fuel jet, with the result that entrainment between the fuel and air was enhanced. The central jet region was formed by two adjacent vorticity-concentrated areas of opposite signs. As acoustic excitation was applied to the central fuel jet, these two areas expanded with increasing jet pulsation intensity. The jet pulsation induced vortical structures periodically evolving from the jet exit with the result that oscillation waveforms of the instantaneous velocities were obtained. The vortical structures entrained fresh air into the central fuel jet in radial direction, resulting in the extreme radial and axial turbulence intensities and improved mixing between fuel and air. © 2014 Elsevier Inc.

Affiliations

Graduate Institute of Applied Science and Technology, National Taiwan University of Science and Technology, Taipei, 10607, Taiwan; Department of Mechanical Engineering, University of San Carlos, Cebu, 6000, Philippines